SUMMARY STEPS TO REPRODUCE 1. I am using two vanishing points and one parallel ruler, to setup 2pt. perspective 2. I do a sketch 3. Then i zoom in and with snapping in pen tool enabled, using pen pressure enabled brush, i draw something with ~150% zoom, the brush works fine. 4. After zooming further to draw details, whenever beyond ~200-250% of zoom, the brush pressure starts to not register properly. 5. Zooming to close decreases pressure registration to the point, where 10px sized brush has problems with leaving any marks on canvas. OBSERVED RESULT Little to no pen pressure detected, ergo no marks on canvas EXPECTED RESULT Normal pressure curve, drawing properly using pen tool and assistants while zoomed in. SOFTWARE/OS VERSIONS Windows: macOS: Windows 10 pro Krita versions tested: from 4.1 to 4.2.7 High DPI support is enabled Touch canvas rotation is disabled Touch canvas panning is enabled ADDITIONAL INFORMATION Thinkpad X1 tablet gen 3. (8650V pro variant) Matte screen protector for some pen grip Both levnovo pro pen 1 and Waccom bamboo ink plus are affected
I'm not seeing this with 4.2.7.1 on Linux or Windows. The only thing I notice is that if the Magnetism is set to the maximum value, I have to move the cursor about 10 pixels away from the start point before the line starts to be drawn along the assistant guide line. Opacity variation with pressure works ok at all zoom levels. This is with a Wacom Draw tablet.
Hi, soldiumek! Could you please make a screen recording of the problem? I have followed your steps and couldn't reproduce any problem. The only thing that I could see is 2px delay between the start of the painting, which is the threshold for selecting the assistant that is going to be followed. PS: Just a wild guess, perhaps you had a Brush Stabilizer mode active and had "Scalable Distance" checkbox activated? It could cause some weird behavior in Krita before Krita 4.3. Could you test it with Krita 4.3 release? https://krita.org/en/item/krita-4-3-0-released/ PPS: I'll mark the bug as needs-info for now.
Dear Bug Submitter, This bug has been in NEEDSINFO status with no change for at least 15 days. Please provide the requested information as soon as possible and set the bug status as REPORTED. Due to regular bug tracker maintenance, if the bug is still in NEEDSINFO status with no change in 30 days the bug will be closed as RESOLVED > WORKSFORME due to lack of needed information. For more information about our bug triaging procedures please read the wiki located here: https://community.kde.org/Guidelines_and_HOWTOs/Bug_triaging If you have already provided the requested information, please mark the bug as REPORTED so that the KDE team knows that the bug is ready to be confirmed. Thank you for helping us make KDE software even better for everyone!
This bug has been in NEEDSINFO status with no change for at least 30 days. The bug is now closed as RESOLVED > WORKSFORME due to lack of needed information. For more information about our bug triaging procedures please read the wiki located here: https://community.kde.org/Guidelines_and_HOWTOs/Bug_triaging Thank you for helping us make KDE software even better for everyone!