Devices ----------------------- MATSHITA DVD-RAM UJ8E2 S 1.00 (/dev/sr0, CD-R, CD-RW, CD-ROM, DVD-ROM, DVD-R, DVD-RW, DVD-R DL, DVD+R, DVD+RW, DVD+R DL) [DVD-ROM, Последовательный DVD-R, Двухслойный последовательный DVD-R, DVD-R Dual Layer Jump, DVD-RAM, DVD-RW с ограниченной перезаписью, Последовательный DVD-RW, DVD+RW, DVD+R, Двухслойный DVD+R, CD-ROM, CD-R, CD-RW] [SAO, TAO, RAW, SAO/R96P, SAO/R96R, RAW/R16, RAW/R96P, RAW/R96R, Ограниченная перезапись, Layer Jump] [%7] K3b::IsoImager ----------------------- mkisofs print size result: 8445 (17295360 bytes) System ----------------------- K3b Version: 2.0.3 KDE Version: 4.14.16 QT Version: 4.8.7 Kernel: 4.4.0-57-generic Used versions ----------------------- mkisofs: 1.1.11 cdrecord: 1.1.11 cdrecord ----------------------- scsidev: '/dev/sr0' devname: '/dev/sr0' scsibus: -2 target: -2 lun: -2 Linux sg driver version: 3.5.27 Wodim version: 1.1.11 SCSI buffer size: 64512 Beginning DMA speed test. Set CDR_NODMATEST environment variable if device communication breaks or freezes immediately after that. TOC Type: 3 = CD-ROM XA mode 2 Driveropts: 'burnfree' Device type : Removable CD-ROM Version : 5 Response Format: 2 Capabilities : Vendor_info : 'MATSHITA' Identification : 'DVD-RAM UJ8E2 S ' Revision : '1.00' Device seems to be: Generic mmc2 DVD-R/DVD-RW. Current: 0x000A (CD-RW) Profile: 0x0012 (DVD-RAM) Profile: 0x002B (DVD+R/DL) Profile: 0x001B (DVD+R) Profile: 0x001A (DVD+RW) Profile: 0x0013 (DVD-RW restricted overwrite) Profile: 0x0014 (DVD-RW sequential recording) Profile: 0x0016 (DVD-R/DL layer jump recording) Profile: 0x0015 (DVD-R/DL sequential recording) Profile: 0x0011 (DVD-R sequential recording) Profile: 0x0010 (DVD-ROM) Profile: 0x000A (CD-RW) (current) Profile: 0x0009 (CD-R) Profile: 0x0008 (CD-ROM) Profile: 0x0002 (Removable disk) Using generic SCSI-3/mmc CD-R/CD-RW driver (mmc_cdr). Driver flags : MMC-3 SWABAUDIO BURNFREE Supported modes: TAO PACKET SAO SAO/R96P SAO/R96R RAW/R16 RAW/R96P RAW/R96R Drive buf size : 262144 = 256 KB FIFO size : 12582912 = 12288 KB Speed set to 2822 KB/s Track 01: data 16 MB Total size: 18 MB (01:52.62) = 8447 sectors Lout start: 19 MB (01:54/47) = 8447 sectors Current Secsize: 2048 ATIP info from disk: Indicated writing power: 1 Reference speed: 0 Is not unrestricted Is erasable Disk sub type: Ultra High speed Rewritable media (2) ATIP start of lead in: -11076 (97:34/24) ATIP start of lead out: 359849 (79:59/74) 1T speed low: 16 1T speed high: 16 2T speed low: 8 2T speed high: 24 power mult factor: 4 5 recommended erase/write power: 1 A1 values: 66 4A 99 A2 values: 38 80 00 A3 values: 04 C4 A0 Disk type: Phase change Manuf. index: 11 Manufacturer: Mitsubishi Chemical Corporation Blocks total: 359849 Blocks current: 359849 Blocks remaining: 351402 Starting to write CD/DVD at speed 16.0 in real TAO mode for multi session. Last chance to quit, starting real write in 2 seconds. 1 seconds. 0 seconds. Operation starts. Waiting for reader process to fill input buffer ... input buffer ready. Performing OPC... Errno: 5 (Input/output error), send opc scsi sendcmd: no error CDB: 54 01 00 00 00 00 00 00 00 00 status: 0x2 (CHECK CONDITION) Sense Bytes: 70 00 03 00 00 00 00 0A 00 00 1D 0E 73 03 00 00 Sense Key: 0x3 Medium Error, Segment 0 Sense Code: 0x73 Qual 0x03 (power calibration area error) Fru 0x0 Sense flags: Blk 0 (not valid) cmd finished after 8.711s timeout 60s /usr/bin/wodim: OPC failed. Writing time: 8.739s /usr/bin/wodim: fifo had 192 puts and 0 gets. /usr/bin/wodim: fifo was 0 times empty and 0 times full, min fill was 100%. cdrecord command: ----------------------- /usr/bin/wodim -v gracetime=2 dev=/dev/sr0 speed=16 -tao driveropts=burnfree -multi -xa -tsize=8445s - mkisofs ----------------------- 8445 I: -input-charset not specified, using utf-8 (detected in locale settings) Using _______________________000.DOCX;1 for /Еженедельный доклад-6.docx (журнал учета передачи информации.docx) Using _______________________001.DOCX;1 for /журнал учета передачи информации.docx (Журнал инструктажа о запрете использования сотовых телефонов.docx) Using _______________________002.DOCX;1 for /Журнал инструктажа о запрете использования сотовых телефонов.docx (Акт на уничтожение флешек.docx) Using ________________________000.DOC;1 for /Временная инструкция по делопроизводству вместо №170.doc (Методика проверки и оценки состояния режима секретности, сог.doc) Using _______________________003.DOCX;1 for /Акт на уничтожение флешек.docx (ОБРАЗЦОВЫЕ ДОКУМЕНТЫ НА ОБЪЕКТ ВТ.docx) Using _______________________004.DOCX;1 for /ОБРАЗЦОВЫЕ ДОКУМЕНТЫ НА ОБЪЕКТ ВТ.docx (частная инструкция АП.docx) Using _______________________005.DOCX;1 for /частная инструкция АП.docx (типовая инструкция АП.docx) Using _______________________006.DOCX;1 for /типовая инструкция АП.docx (Приказ о назначении ответственного за ЗИ.docx) Using _______________________007.DOCX;1 for /Приказ о назначении ответственного за ЗИ.docx (Приказ о закреплении.docx) Using __________________59313000.DOCX;1 for /Приказ АП 59313-39 185.docx (Приказ АП 59313-39 о допуске личного состава185.docx) Using _______________________008.DOCX;1 for /Приказ о закреплении.docx (Приказ АП о закреплении технических средств.docx) 6.05% done, estimate finish Mon Jan 16 01:54:37 2017 11.84% done, estimate finish Mon Jan 16 01:54:29 2017 17.82% done, estimate finish Mon Jan 16 01:54:26 2017 23.84% done, estimate finish Mon Jan 16 01:54:25 2017 29.71% done, estimate finish Mon Jan 16 01:54:24 2017 35.58% done, estimate finish Mon Jan 16 01:54:23 2017 41.46% done, estimate finish Mon Jan 16 01:54:23 2017 47.52% done, estimate finish Mon Jan 16 01:54:23 2017 53.39% done, estimate finish Mon Jan 16 01:54:22 2017 59.27% done, estimate finish Mon Jan 16 01:54:22 2017 65.14% done, estimate finish Mon Jan 16 01:54:22 2017 71.20% done, estimate finish Mon Jan 16 01:54:22 2017 mkisofs calculate size command: ----------------------- /usr/bin/genisoimage -gui -graft-points -print-size -quiet -volid Проект данных K3b -volset -appid K3B THE CD KREATOR (C) 1998-2010 SEBASTIAN TRUEG AND MICHAL MALEK -publisher -preparer -sysid LINUX -volset-size 1 -volset-seqno 1 -sort /tmp/kde-nikolay/k3bPS3922.tmp -rational-rock -hide-list /tmp/kde-nikolay/k3bGm3922.tmp -joliet -joliet-long -hide-joliet-list /tmp/kde-nikolay/k3bNY3922.tmp -no-cache-inodes -full-iso9660-filenames -iso-level 3 -path-list /tmp/kde-nikolay/k3beo3922.tmp mkisofs command: ----------------------- /usr/bin/genisoimage -gui -graft-points -volid Проект данных K3b -volset -appid K3B THE CD KREATOR (C) 1998-2010 SEBASTIAN TRUEG AND MICHAL MALEK -publisher -preparer -sysid LINUX -volset-size 1 -volset-seqno 1 -sort /tmp/kde-nikolay/k3bDF3922.tmp -rational-rock -hide-list /tmp/kde-nikolay/k3bDj3922.tmp -joliet -joliet-long -hide-joliet-list /tmp/kde-nikolay/k3bGx3922.tmp -no-cache-inodes -full-iso9660-filenames -iso-level 3 -path-list /tmp/kde-nikolay/k3btZ3922.tmp
Hi edtit5, 1. I am maintaining k3b for KF5 right now https://github.com/KDE/k3b it will be released as KDE Applications 17.04.0 soon! but v2.0.3 was not be maintained any more! 2. you can use CDEmu to test http://www.leetcode.cn/2016/08/k3b.html#test Regards, Leslie Zhai
Thank you for reporting this issue in KDE software. As it has been a while since this issue was reported, can we please ask you to see if you can reproduce the issue with a recent software version? If you can reproduce the issue, please change the status to "REPORTED" when replying. Thank you!
Dear Bug Submitter, This bug has been in NEEDSINFO status with no change for at least 15 days. Please provide the requested information as soon as possible and set the bug status as REPORTED. Due to regular bug tracker maintenance, if the bug is still in NEEDSINFO status with no change in 30 days the bug will be closed as RESOLVED > WORKSFORME due to lack of needed information. For more information about our bug triaging procedures please read the wiki located here: https://community.kde.org/Guidelines_and_HOWTOs/Bug_triaging If you have already provided the requested information, please mark the bug as REPORTED so that the KDE team knows that the bug is ready to be confirmed. Thank you for helping us make KDE software even better for everyone!
This bug has been in NEEDSINFO status with no change for at least 30 days. The bug is now closed as RESOLVED > WORKSFORME due to lack of needed information. For more information about our bug triaging procedures please read the wiki located here: https://community.kde.org/Guidelines_and_HOWTOs/Bug_triaging Thank you for helping us make KDE software even better for everyone!