Version: unspecified (using KDE 4.6.3) OS: Linux If I add two points (A and B) to the map Marble can calculate the route between these two points. If I put the mouse over the route (mouse pointer changes to green flag) and then drag it to some other point, the new point is marked as B, it is added to the list of routing points (on the left side of the screen) but the route itself simply ignores the newly added middle point B. Marble version 1.1.0 Reproducible: Always Steps to Reproduce: 1. Put a starting and end point of the route on the map (route is calculated) 2. Hover a mouse over the root and drag it to add a new point. Actual Results: New point is added but route is not recalculated (if recalculating manually newly added point is ignored) Expected Results: Route is recalculated to go from A to B and then from B to C. It used to work some time ago on previous versions...
The yours backend shows that behavior, it doesn't support via points yet. OpenRouteService and the offline map backends all support via points and should recalculate the route. Can you deactivate yours in the configuration and try again with openrouteservice? Maybe openrouteservice.org was down when you tried.
Apparently this one is caused by the same problem as "pedestrian/cycle" routing. If I run marble with english language route adjusting starts working. If I run marble like this: LANG=lt_LT.UTF-8;marble it does not recalculate the route...
You're right about the localization problem. Let's track that in bug 273884. I'll take the liberty to reuse this bug for the missing via point support in the yours backend.
Thank you for the bug report. As this report hasn't seen any changes in 5 years or more, we ask if you can please confirm that the issue still persists. If this bug is no longer persisting or relevant please change the status to resolved.